User manual SKIL 8120

[. . . ] Safety equipment such as dust mask, non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will reduce personal injuries. Stay alert, watch what you are doing and use common sense during operation. Do not use appliance while you are tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating appliance may result in serious personal injury. [. . . ] Some dust created by this product contains chemicals know to the State of California to cause cancer, birth defects or other reproductive harm. Some of these chemicals include fertilizers, insecticides, herbicides, pesticides, as well as arsenic and chromium from chemically treated lumber. To reduce your exposure to these chemicals, wear approved safety equipment such as dust masks that are specifically designed to filter out microscopic particles. Battery charger, read all instructions and cautionary markings on (1) battery charger, and (2) product using battery. Use only the charger which accompanied your product or direct replacement as listed in the catalog or this manual. Do not disassemble charger or operate the charger if it has received a sharp blow, been dropped or otherwise damaged in any way. If battery case is cracked or otherwise damaged, do not insert into charger. Other types of batteries may burst causing personal injury and damage. Charge unit in temperatures above +32 degrees F (0 degrees C) and below +113 degrees F (45 degrees C). Store unit in locations where temperatures will not exceed 120 degrees F (49 degrees C). If liquid comes in contact with skin, wash quickly with soap and water. If the liquid contacts your eyes, flush them with water for a minimum of 10 minutes and seek medical attention. Place charger on flat non-flammable surfaces and away from flammable materials when re-charging unit. Carpeting and other heat insulating surfaces block proper air circulation which may cause If smoke or melting of the case are observed unplug the charger immediately and do not use the unit or charger. Use of an attachment not recommended or sold by Skil may result in a risk of fire, electric shock or injury to persons. INSTALLATION INSTRUCTIONS To Reduce the Risk of Electric Shock, this appliance has a polarized plug (one blade is wider than the other). If it still does not fit, contact a qualified electrician to install the proper outlet. For example, to protect terminals from shorting DONOT place batteries in a tool box or pocket with nails, screws, keys, etc. WARNING semble the battery or remove any component projecting from the battery terminals. Prior to disposal, protect exposed terminals with heavy insulating tape to prevent shorting. LITHIUM-ION BATTERIES If equipped with a lithium-ion battery, the battery must be collected, recycled or disposed of in an environmentally sound manner. "The EPA certified RBRC Battery Recycling Seal on the lithium-ion (Li-ion) battery indicates Robert Bosch Tool Corporation is voluntarily participating in an industry program to collect and recycle these batteries at the end of their useful life, when taken out of service in the United States or Canada. [. . . ] When the battery is empty, the tool is switched off by means of a protective circuit. CAUTION battery, do not continue to press the On/Off switch after the tool has been automatically switched off. CHARGING THE TOOL Plug charger cord into your standard power outlet, then insert tool into charger (Fig. The green charging indicator light on the tool will turn "ON". [. . . ]