User manual SKIL 8201-CL

[. . . ] ALWAYS use only the accessories that are recommended by the manufacturer of your laser tool. Use of accessories that have been designed for use with other laser tools could result in serious injury. DO NOT use this laser tool for any purpose other than those outlined in this manual. DO NOT leave the laser tool "ON" unattended in any operating mode. [. . . ] Check for misalignment or binding of moving parts, breakage of parts and any other condition that may affect the operation. , in accordance with these instructions and in the manner intended for the particular type of tool, taking into account the working conditions and the work to be performed. Use of the tool for operations different from those intended could result in a hazardous situation. Service Have your tool serviced by a qualified repair person using only identical replacement parts. When cleaning a tool be careful not to disassemble any portion of the tool since internal wires may be misplaced or pinched or may be improperly mounted. Inserting/Replacing the Battery ALWAYS turn off the laser and the main power switch before removing and replacing the batteries. Remove the battery cover by sliding it towards the bottom of the instrument. When inserting, pay attention to the correct polarity according to the representation on the inside of the battery compartment. ⷠRemove the batteries from the tool when not using it for extended periods. When storing for extended periods, the batteries can corrode and discharge themselves. 1 2 3 4 5 Power switch Laser mode indicator (LED) Laser aperture Battery compartment 1/4-20 tripod mount Other Features (not shown) 6 Laser warning label 7 Protective case* 8 Tripod* *The accessories illustrated or described are not included as standard delivery. In case of large variations in temperature, allow the tool to adjust to the ambient temperature before putting it into operation. After heavy exterior impact on the tool, an accuracy check should always be carried out before continuing to work (see "Leveling Accuracy"). Switch off the leveling unit, which can be damaged in the case of intense movement. Turning on the Tool To switch on the tool, push the On/Off switch 1 once. Immediately after switching on, the tool sends one laser beam out of the exit opening 3. ⷠDo not point the laser beam at persons or animals and do not look into the laser beam yourself, not even from a large distance. ⷠDo not leave the switched on tool unattended and switch the tool off after use. Automatic Leveling Working with Automatic Leveling Position the tool on a level and firm surface, hold it by the b against a vertical surface or attach it to a tripod 8. After switching on, the leveling function automatically compensates irregularities within the self-leveling range of ±4°. [. . . ] Place the tool via the tripod mount 5 onto the 1/4-20 male thread of the tripod and screw the locking screw of the tripod tight. Regularly clean the surfaces at the exit opening of the laser in particular, and pay attention to any fluff of fibers. If the tool should fail despite the care taken in manufacturing and testing procedures, repair should be carried out by an authorized aftersales service center for SKIL power tools. In all correspondence and spare parts orders, please always include the 10-digit article number given on the type plate of the tool. [. . . ]