User manual TELTONIKA FM2 QUICK GUIDE V1.3

[. . . ] Reproduction, transfer, distribution or storage of part or all of the contents in this document in any form without the prior written permission of Teltonika is prohibited. 1 1. Physical connection 1. 1 SIM card insert scheme SIM card must have PIN code request disabled. Figure 1. SIM card insert scheme Open the SIM holder and insert the SIM card as shown. Close the SIM holder Push SIM holder's top part in shown direction to clip SIM holder Assemble device with enclosure's top part as shown and screw the bolts. 2 1. 2 Power supply connection DIN 1 DIN 2 VCC (10÷30)V DC (+) 3 2 1 6 5 4 OUT 2 OUT 1 GND(VCC(10÷30)V DC)(-) Figure 2. [. . . ] 'Min Saved Records' defines minimum number of coordinates that should be transferred with one connection to server. If FM2 does not have enough coordinates to send to server, it will check again after time interval defined in 'Sending Period' (see below). 5 2. 5 GPRS settings 'GPRS Settings' define two main parameters for FM2: GSM operator APN and GPRS username and password (optional ­ depending on operator), and destination server IP and port. Some operators use specific authentification for GPRS session ­ CHAP or PAP. If any of these is used, APN should be entered as '<APN>:c' or '<APN>:p'. if operator is using APN 'internet' with CHAP authentification, it should be entered as 'internet:c'. Information about APN and authentification type should be provided by your GSM operator. 6 2. 6 SMS Settings Essential fields in 'SMS Settings' are 'Login' and 'Password'. This login and password should be used with every SMS sent to FM2 as identifiers and means of protection from SMS from unauthorised numbers. More information about SMS sending can be found in 'FM2 SMS Command List' document. 'SMS Data Send' field defines if FM2 is able to send periodic data and high priority event SMS to the server. Note, that it does not prevent FM2 from sending back replies to configuration commands or requests. Periodic data messages are sent in binary format to number specified in 'Server Phone Number' field. If any number is entered in 'Server Phone Number' field, then that number is considered as only number authorised to send SMS ­ FM2 will discard all messages received from other numbers. More numbers can be added in 'Authorized Phone Numbers' list (up to 8). 7 2. 7 Send parameters 'Send Parameters' contains main information about data transfer. 'Send Period' defines time interval for FM2 to check if it has enough coordinates (number defined by 'Min. Saved Records' in 'GSM Settings') and if so ­ open connection with server and send them. Before data link with server is opened, FM2 checks if GPRS connection is available. If not, then it checks if it can be opened: 'Send Week Time' table indicates when new GPRS connection can be opened. FM2 algorithm allows to open new GPRS session if current time is less than 10 minutes before nearest checked timestamp, therefore if all table is checked, FM2 is always allowed to open new GPRS session. FM2 is able to use GPRS transfers only if currently used operator is entered in 'Operators List'. Usually home network code and roaming partner codes are entered in this list. If FM2 connects to an operator that is not included in the list, it is not able to use GPRS no matter what 'Send Week Time' table indicates. [. . . ] Download Terminal from: http://213. 226. 139. 30/Downloads/Software/Terminal. rar. After launching it choose baud rate 115200 and hardware control ­ none. Then click 'Connect' to start receiving messages from FM2. 4. Compatibility FM2 uses FM4 data protocol as well as configuration protocol. [. . . ]