User manual TERRAILLON DIGITAL BATH AND AMBIENT THERMOMETER

[. . . ] Charging Bay charges network hubs when they are not in use. • You must have administrative rights to install • Before installing TI-Navigator™ software, you must install TI Connect™ 1. 6 from the CD. • You must upgrade the operating system on your TI calculators to 1. 19 or higher (TI-83 Plus), 2. 41 or higher (TI-84 Plus), or 1. 90 or higher (TI-73 Explorer™). [. . . ] • You must upgrade the operating system on your TI calculators to 1. 19 or higher (TI-83 Plus), 2. 41 or higher (TI-84 Plus), or 1. 90 or higher (TI-73 Explorer™). For more information, see the Installation Guide. • For detailed set-up instructions, see the Installation Guide. For quick access to information while using the software, see the TI-Navigator™ Reference Guide or the TI-Navigator™ Help. AC9 940 Contact TI for additional help On the Web By e-mail By phone education. ti. com/support ti-navigator@ti. com 1-866-TI NAVIGATOR (1-866-846-2844) Texas Instruments 7800 Banner Dr. Dallas, Texas 75251 NAV/PO/1L1/G © Texas Instruments 2005, 2008 TI-Navigator™ 3. 2 Getting Started poster 2 Assemble and charge the hubs Connect network connectors onto hubs. For detailed instructions, see the Installation Guide. 3 Place hubs in charging bay to recharge. Install TI-Connect™ and TI-Navigator™ software d) When the installer program asks for it, type the System ID for your TI-Navigator™ system. You can find the System ID inside the CD case. 4 Set up your network a) Insert the software installation CD in the CD-ROM drive. b) When the window opens, click the Computer Software button, and install TI-Connect™ 1. 6 software on the computer. Please follow all the steps as instructed on the screen. • You must upgrade the operating system on your TI calculators to 1. 19 or higher (TI-83 Plus), 2. 41 or higher (TI-84 Plus), or 1. 90 or higher (TI-73 Explorer™). See the Installation Guide for more information on upgrading the calculator operating system. (An operating system may take ten minutes per calculator to transfer and install. ) • For quick access to information while using the software, see the TI-Navigator™ Reference Guide or the TI-Navigator™ Help. b) Connect the USB cable to the access point. d) Connect the USB cable from the access point to the computer’s USB port. b b) Next, you will add the hubs. When prompted, insert a ball point pen into the hole at the back of each hub to press and hold the Reset button. The hub’s LEDs begin to flash amber. LEDs Reset USB Cable c) Hold the Reset button until all three LEDs show solid amber. [. . . ] d) Connect the USB cable from the access point to the computer’s USB port. b b) Next, you will add the hubs. When prompted, insert a ball point pen into the hole at the back of each hub to press and hold the Reset button. [. . . ]