User manual VELODYNE SC-600 IC INSTALLATION REV A

[. . . ] The SC-600, a rack-mountable amplifier that powers the SC-600 Series, features 400 watts dynamic / 200 watts RMS power. The SC-600 IF/IC can be installed in a variety of locations and positions for a given installation. [. . . ] From the centerline of the subwoofer driver, mark off the dimensions of the grille opening to accommodate the decorative grille chosen for the end user installation. Make whatever modifications are required to enable the subwoofer to fit in the installation location. Note that the SC-600 IF/IC is designed for joists on 16" centers. MAKE SURE STRIPS ARE USED ANYWHERE THE CABINET WILL COME INTO CONTACT WITH THE STRUCTURE IN ANY WAY. The SC-600 IF/IC is a powerful subwoofer and will likely buzz or rattle if not isolated from the structure using the provided foam strips. Figure 2: Affix foam strips. . www. velodyne. com SC-600 IF/IC User's Manual 3 Step 6 Install. Place the SC-600 IF/IC as determined in step two and attach the brackets loosely. Either use a partner to suspend the subwoofer while you are attaching it or use a mechanical device to hold it in place during installation. Figure 3: SC-600 IF (In-Floor) positioned into floor location. . www. velodyne. com SC-600 IF/IC User's Manual 4 Step 7 Adjust bracket position and tighten. Position the subwoofer into its final location and tighten the brackets. Figure 4: Tighten the brackets. . www. velodyne. com SC-600 IF/IC User's Manual 5 Step 8 Secure wiring. Twist the wire strands tightly before inserting them in the terminals. Do not allow stray wires from one terminal to touch the other terminal. Be sure to secure the speaker wire so it does not rattle or buzz against the cabinet during use. Figure 5a, 5b, and 5c: Speaker wire connection. . www. velodyne. com SC-600 IF/IC User's Manual 6 Step 9 Complete installation. Install the decorative grille and perform any other tasks needed to complete the installation based on chosen woofer positioning. [. . . ] If VELODYNE determines the unit is defective, VELODYNE will, at VELODYNE's option, repair or replace the product at no charge if the product is forwarded prepaid to a factory authorized service representative. Products forwarded to the factory authorized service representative should be shipped securely and properly packaged, insured and freight prepaid. [. . . ]