User manual VIETA CTF72MC

[. . . ] Use the factory-installed fuse or one with the same specifications should you have to change it. Be careful with electricity when changing the original as this may cause the appliance to burn or catch fire. [. . . ] 2. 3. 4. 5. 6. 7. 3 Operating the Display Unit a b c d e f POWER: Switching the unit ON and OFF VOL -: Decrease Volume VOL +: Increase Volume MENU: Select button to access the on-screen OSD menu and adjustment selection AUX: Source selection IR SENSOR: There is an IN Sensor that receives the remote control commands and the wireless headphones at the front of the housing DOME LIGHT SWITCH: The built-in Dome Light has three operating modes ON- The Dome Light remains ON at all times OFF- The Dome Light remains OFF at all times DOOR-The Dome Light will turn ON and OFF whenever the vehicle's doors are opened or closed, respectively. h MONITOR OPEN BUTTON: Press this button to release the Monitor Panel. To close, press the LCD Monitor Panel firmly back up into the housing until a click is heard g i LED DOME LIGHT: The Dome Light using LED j k l HEADPHONE OUTPUT1: Output jack is provided for wired headphones AUX3 INPUT: Audio and video input (A/V) AUX3 HEADPHONE OUTPUT2: Output jack is provided for wired headphones 4 Operating the Remote Control a b c d e f PWR: Turns the unit ON and OFF (AUX1. AUX2 switch) CH+: changes TV channels up CH-: changes TV channels down VOL+: Volume increase VOL-: Volume decrease MENU: On-screen menu access/exit OSD 5 SmartView Swivel Mechanism 1. The screen will automatically open Warning The screen can be extended to a maximum angle of 105º. Pushing it beyond this point could damage the device. 3. Manually adjust the screen position to your preferred angle 4. Adjust left and right angles as shown below: Warning V The left/ right positions can be extended to a maximum angle of 25º. Pushing it beyond this point could damage the device. 6 SmartView Swivel Mechanism 5. V Turning off the device Before turning off the device, centre the screen and continue to push upwards to turn off the device fully. Warning V V Make sure the screen has been centered before pushing upwards to turn off the device fully or the device could be damaged. Before pushing the screen upwards to turn off the device, do not turn the screen left or right as this could damage the device. Before closing the screen fully, please ensure no external particles or residue is left on the screen. V 7 Adjusting the Volume Adjusting the Volume V. Gently press the Remote Control or press the "Vol +" button on the device to increase the volume Gently press the Remote Control or press the "Vol -" button on the device to lower the volume Note: Under normal circumstances, the "Vol +"and "Vol -" buttons are used to control the volume and not to adjust the menu. Lighting (LIGHT) On the Menu screen, select the 'LIGHT' option to begin adjusting the picture lighting. You can choose LIT1, LlT2, LIT3 and LIT4 picture lighting options. Symmetry (REV) On the Menu screen, select the 'REV' option to begin adjusting the symmetry. [. . . ] Yellow Lead: Plugged into a socket that receives 12 V directly from the battery. Red Lead: Positive connection behind the ignition key Black Lead: Earth connection (negative) Blue Lead: Connect DOOR lighting control wire to vehicle interior light function. 2. [. . . ]