User manual VIOLET DESIGN PEARL-VOCAL BROCHURE
DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!
If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual VIOLET DESIGN PEARL-VOCAL. We hope that this VIOLET DESIGN PEARL-VOCAL user guide will be useful to you.
Manual abstract: user guide VIOLET DESIGN PEARL-VOCALBROCHURE
Detailed instructions for use are in the User's Guide.
[. . . ] [. . . ] It has been tuned specifically for a modern, detailed vocal sound with extended vocal presence and optimized low-end response. The newly developed suspension system effectively reduces handling noise to an absolute minimum and the cardioid polar pattern has been optimized for maximum side and rear rejection while providing maximum gain before feedback. This is the ideal microphone for live jazz, pop, and rock vocalists, but also provides superior sound for brass, woodwinds, percussion, drums, and is exceptional for capturing guitar amplifiers. The Pearl Vocal is available in dark grey, violet, red, and white matte finishes, comes with a holder, and is packaged in a fine hardwood box.
+8 db O -8
FREQUENCY CHART: PEARL VOCAL
20
30
50 70 100
200 300
500 700 1k Hz
2k
3k
5k 7k 10k
20k
SPECIFICATIONS
Transducer type: TRUE polarized electrostatic, single diaphragm Operating principle: pressure gradient Diaphragm's active diameter: 0. 8" (21 mm), center tapped Frequency range: 50 Hz to 20 kHz Polar pattern: unidirectional (optimized between wide cardioid, cardioid, and supercardioid, depending on frequency) Output impedance: 50 ohms Rated load impedance: 1000 ohms Suggested load impedance: > 250 ohms Sensitivity at 1000 Hz into 1000 ohms load: 12 mV/Pa S/N Ratio CCIR 468-3 weighted: 70 dB S/N Ratio DIN/IEC 651 A-weighted: 80 db-A Equivalent noise level DIN/IEC A-weighted: 14 dB-A Maximum SPL for 0. 5% THD at 1000 ohm load: 144 dB Dynamic range of the microphone preamplifier: 130 db Phantom powering voltage on XLR pins 2 & 3 relatively pin 1: +48 V (±4 V) Phantom current consumption: < 1. 5 mA Output connector: 3-pin XLR male, gold plated contacts Signal polarity: pin 2 in phase Dimensions: 8. 15" x 1. 67" (207 x 42. 5mm) head diameter, 0. 96" (24. 5mm) shaft diameter Exclusively distributed in the Americas by Weight: 12. 3 oz. [. . . ] [. . . ]
DISCLAIMER TO DOWNLOAD THE USER GUIDE VIOLET DESIGN PEARL-VOCAL
Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual VIOLET DESIGN PEARL-VOCAL will begin.