User manual WEED EATER BV200 BV1650 BV1800 BV1850 BV2000

DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Diplodocs provides you a fast and easy access to the user manual WEED EATER BV200 BV1650 BV1800 BV1850 BV2000. We hope that this WEED EATER BV200 BV1650 BV1800 BV1850 BV2000 user guide will be useful to you.


WEED EATER BV200 BV1650 BV1800 BV1850 BV2000 : Download the complete user guide (378 Ko)

Manual abstract: user guide WEED EATER BV200 BV1650 BV1800 BV1850 BV2000

Detailed instructions for use are in the User's Guide.

[. . . ] ENGLISH R Trademark Instruction Manual Manual de Instrucciones Manuel d'Instructions BV200 / BV1650 / BV1800 BV1850 / BV2000 ESPAÑOL IMPORTANT MANUAL - Do not throw away MANUAL IMPORTANTE - No lo descarte MANUEL IMPORTANT - À Conserver WARNING: Read and follow all Safety Rules and Operating Instructions before using this product. ADVERTENCIA: Lea el manual de instrucciones y siga todas las advertencias e instrucciones de seguridad. AVERTISSEMENT: Veuillez lire le manuel d'instructions et bien respecter tous les avertissements et toutes les instructions de sécurité. Tout défaut de le faire pourrait entraîner des blessures graves. Electrolux Home Products North America Div. [. . . ] Push lower vacuum tube into upper vacuum tube. Upper Vacuum Tube Lower Vacuum Tube Insert a screwdriver into the latch area on the vacuum inlet cover. Blower Latch Outlet Area Latch Area Vacuum Inlet Cover Gently tilt the handle of the screwdriver toward the back of the unit while pulling up on the vacuum inlet cover with your other hand. Hold the vacuum inlet cover open until upper vacuum tube is installed. Vacuum Inlet Retaining Post Vacuum Inlet Cover Place the hooks on the vacuum tube on the retaining posts; pivot tube into position. Secure vacuum tube by turning the knob clockwise until tight. D D USING YOUR UNIT WARNING: You MUST make sure the tubes are secure before using the unit. OPERATING POSITION Eye Protection D D Blower Vacuum OPERATING TIPS D S While vacuuming or blowing debris, hold the unit with the muffler side facing away from your body and clothes (see illustration above). -- 4 -- S To reduce the risk of hearing loss associated with sound level(s), hearing protection is required. S To reduce the risk of injury associated with contacting rotating parts, stop the engine before installing or removing attachments. S Operate power equipment only at reasonable hours--not early in the morning or late at night when people might be disturbed. S To reduce noise levels, limit the number of pieces of equipment used at any one time. S Move throttle lever to the S Move choke lever to the FULL CHOKE position. Throttle Lever Primer Button IMPORTANT Experience indicates that alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. To avoid engine problems, empty the fuel system before storage for 30 days or longer. Drain the gas tank, start the engine and let it run until the fuel lines and carburetor are empty. Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur. Choke Lever S Pull starter rope sharply until engine attempts to run, but no more than 5 pulls (below 30_ F, 8 pulls). NOTE: If engine attempts to start before the 5th pull, go to next step immediately. S Move the choke lever to the HALF CHOKE position. -- 5 -- S Pull the starter rope sharply until the engine runs, but no more than 5 pulls (below 30_ F, 10 pulls). S Allow the unit to run for 30 more seconds at the RUN position before moving the throttle lever to position. If engine has not started after 5 pulls (at HALF CHOKE), repeat STARTING A COLD ENGINE procedure. If engine still does not start, proceed to STARTING A FLOODED ENGINE. S Vacuum Bag -- Do not use vacuum bag if it is torn or damaged. INSPECT AND CLEAN UNIT AND DECALS S After each use, inspect complete unit for loose or damaged parts. S Wipe off unit with a clean dry cloth. CLEAN AIR FILTER STARTING A WARM ENGINE position. S Move throttle lever to the S Pull starter rope sharply until engine runs, but no more than 5 pulls. If engine still does not run, it is probably flooded. Air Filter Cover STARTING A FLOODED ENGINE S Move the choke lever to the RUN position. S Move throttle lever to the S Pull rope to clear engine of excess fuel. [. . . ] POULAN/WEED EATER must warrant the emission control system on your lawn and garden equipment engine for the periods of time listed below provided there has been no abuse, neglect, or improper maintenance of your lawn and garden equipment engine. Your emission control system includes parts such as the carburetor and the ignition system. Where a warrantable condition exits, POULAN/WEED EATER will repair your lawn and garden equipment engine at no cost to you. MANUFACTURER'S WARRANTY COVERAGE: If any emissions related part on your engine (as listed under Emissions Control Warranty Parts List) is defective or a defect in the materials or workmanship of the engine causes the failure of such an emission related part, the part will be repaired or replaced by POULAN/WEED EATER. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE WEED EATER BV200 BV1650 BV1800 BV1850 BV2000




Click on "Download the user Manual" at the end of this Contract if you accept its terms, the downloading of the manual WEED EATER BV200 BV1650 BV1800 BV1850 BV2000 will begin.

 

Copyright © 2015 - manualRetreiver - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.